收藏本站
LTM4605
APPLICATIONS INFORMATION
R SENSE Selection and Maximum Output Current
R SENSE is chosen based on the required inductor current.
the internal reference and the output voltage. The total
soft-start time can be calculated as:
Since the maximum inductor valley current at buck mode
is much lower than the inductor peak current at boost
mode, different sensing resistors are suggested to use
t SOFTSTART =
2.4V ? C SS
1.7μA
in buck and boost modes.
The current comparator threshold sets the peak of the
inductor current in boost mode and the maximum inductor
valley current in buck mode. In boost mode, the allowed
maximum average load current is:
When the RUN pin falls below 1.6V, then soft-start pin is
reset to allow for proper soft-start control when the regula-
tor is enabled again. Current foldback and force continuous
mode are disabled during the soft-start process. The soft-
start function can also be used to control the output ramp
up time, so that another regulator can be easily tracked.
Δ I L ? V IN
? 160mV
I OUT(MAX,BOOST) = ?
? R SENSE
?
? ?
2 ? V OUT
Do not apply more than 6V to the SS pin.
Run Enable
where Δ I L is peak-to-peak inductor ripple current.
In buck mode, the allowed maximum average load cur-
rent is:
130mV Δ I L
I OUT(MAX,BUCK) = +
R SENSE 2
The maximum current sensing R SENSE value for the boost
mode is:
R SENSE(MAX,BOOST) =
2 ? 160mV ? V IN
2 ? I OUT(MAX,BOOST) ? V OUT + Δ I L ? V IN
The maximum current sensing R SENSE value for the buck
mode is:
The RUN pin is used to enable the power module. The pin
can be driven with a logic input, and not exceed 6V.
The RUN pin can also be used as an undervoltage lockout
(UVLO) function by connecting a resistor from the input
supply to the RUN pin. The equation:
R + 100k
V _UVLO = ? 1.6V
100k
Power Good
The PGOOD pin is an open drain pin that can be used to
monitor valid output voltage regulation. This pin monitors
a ±7.5% window around the regulation point, and tracks
with margining.
COMP Pin
R SENSE(MAX,BUCK) =
2 ? 130mV
2?I OUT(MAX,BUCK) – ΔI L
This pin is the external compensation pin. The module
has already been internally compensated for most output
voltages. A spice model is available for other control loop
A 20% to 30% margin on the calculated sensing resistor is
usually recommended. Please refer to Table 3 for the rec-
ommended sensing resistors for different applications.
Soft-Start
The SS pin provides a means to soft-start the regulator.
A capacitor on this pin will program the ramp rate of the
output voltage. A 1.7μA current source will charge up the
external soft-start capacitor. This will control the ramp of
optimization.
Fault Conditions: Current Limit and Overcurrent
Foldback
LTM4605 has a current mode controller, which inherently
limits the cycle-by-cycle inductor current not only in steady
state operation, but also in transient. Refer to Table 3.
To further limit current in the event of an overload condi-
tion, the LTM4605 provides foldback current limiting. If the
4605fc
12
发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

*型号 *数量 厂商 批号 封装
添加更多采购

我的联系方式

*
*
*
相关PDF资料
LTM4606MPV#PBF IC DC/DC UMODULE 6A 133-LGA
LTM4607IV#PBF IC BUCK/BOOST SYNC ADJ 5A 141LGA
LTM4608AEV#PBF IC BUCK SYNC ADJ 8A 68LGA
LTM4608IV#PBF IC DC/DC UMODULE 8A 68-LGA
LTM4609IV#PBF IC BUCK/BOOST SYNC ADJ 4A 141LGA
LTM4612IV#PBF IC BUCK SYNC ADJ 5A 133LGA
LTM4613MPV#PBF IC UMODULE DC/DC 8A 133-LGA
LTM4614IV#PBF IC UMODULE DC/DC DUAL 4A 144LGA
相关代理商/技术参数
LTM4605EV#PBF 制造商:Linear Technology 功能描述:IC SMPS CONTROLLER CURRENT-MODE LGA
LTM4605EVPBF 制造商:Linear Technology 功能描述:Conv DC-DC Step Up Step Down
LTM4605EV-PBF 制造商:LINER 制造商全称:Linear Technology 功能描述:High Effi ciency Buck-Boost DC/DC μModule
LTM4605IV#PBF 功能描述:IC DC/DC UMODULE 5A 141-LGA RoHS:是 类别:电源 - 板载 >> DC DC Converters 系列:µModule® 设计资源:VI-200, VI-J00 Design Guide, Appl Manual 标准包装:1 系列:* 类型:隔离 输出数:1 电压 - 输入（最小）:21V 电压 - 输入（最大）:32V Voltage - Output 1:5V Voltage - Output 2:- Voltage - Output 3:- 电流 - 输出（最大）:* 电源（瓦） - 制造商系列:100W 电压 - 隔离:* 特点:* 安装类型:通孔 封装/外壳:9-SlimMod 尺寸/尺寸:4.60" L x 1.80" W x 0.52" H（116.8mm x 45.7mm x 13.2mm） 包装:散装 工作温度:-25°C ~ 85°C 效率:* 电源（瓦特）- 最大:*
LTM4605IV#PBF 制造商:Linear Technology 功能描述:DC/DC MICRO MODULE IC
LTM4605IVPBF 制造商:Linear Technology 功能描述:Conv DC-DC Step Up Step Down
LTM4605IV-PBF 制造商:LINER 制造商全称:Linear Technology 功能描述:High Effi ciency Buck-Boost DC/DC μModule
LTM4605RD 功能描述:LED 电路板指示器 Vert LED Assmbly 5mm Red RoHS:否 制造商:Lumex LED 大小:3 mm 照明颜色:Green 波长:565 nm 光强度:30 mcd 安装类型:SMD/SMT 显示角:60 deg 封装:Reel